PAGE1 OF8 P/N 545855E DATEOFISSUE 11 / 2003 INSTALLATION INFORMATION AEROTECH BUILT- IN OVENS 0S301 / 0D301 SERIES IMPORTANT- SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE
BEFORE YOU START PAGE 2 OF 8 Correct installation is the responsibility of the customer. Ensure that the installer is properly qualified to install this oven. = Make surethat the oven is located away from any strong and/or hot drafts of air, • Thecabinet openingdimensionsspecifiedare the absolute minimum. These dimensionsallow a clearance of up to 1/4"(6mm). ° The product must be electrically grounded.
PRODUCT DIMENSIONS PAGE 3 OF 8 28 1/4" (718mm) .\ 28 1/4" (718mm) AE E O ,\ LO v % Z- E O LO v _U --_ US 0S301 51 0D301 29 3/4" (757mm) 29 3/4" (757mm) ...... o AE E p,.. F, .C.. % -.T. p..
PROUD DiMENSiONS RECESSED DiMENSiONS PAGE 4 OF 8 TOP VIEW TOP VIEW Minimum Distance Under Benchtop for Single ovens 2 314"{70ram) Minimum Distance Under Benchtop for Single 2 3/4" (70ram} .
PREPARING THE OVEN ELECTRICAL REQUIREMENTS PAGE 5 OF 8 Unpacking the oven Do not usedoor handlesor any part of the controlpanel for liftingthe product. Beforethe productis lifted, the oven doorsand racks are to be removed. The electricalvoltage and frequencythat is correct for this oven is stated on the serial numberplate located insidethe top vent. It is the customer responsibilityto ensurethat this oven is connectedto the correct electrical supply.
ELECTRICAL CONNECTION PAGE 6 OF 8 This oven is manufactured with white (neutral) power supply wire and a cabinet-connected green grounding wire taped together. Feedthe oven cablethrough the opening in the cabinet. Make the electrical connectionfollowing the steps appropriatefor your installation, 1. Disconnectthe power supply. ------_WARNING : Failureto disconnectthe power supplymay result in death or injury. 2. 3. 4. 5. 6. Removethe junction box cover.
A TTA CHMEN T PAGE 7 OF 8 1. Feed the electrical supplycable into 1" holecut out of the rear of the oven cabinet. WARNING : Extremecare to may be taken when liftingthe productas it is very heavy. Failureto doisso result in injury. Slide the product into the oven cabinet, pushingthe product betweenthe two oven cavities or by the edges of the oven cavity.
CHECKLIST TROUBLE SHOOTING PAGE 8 OF 8 1. Make sure product is level and securelyfitted to the cabinetry and both oven doorsopen and close freely. 2. Make sure all the internal packaginghas been removedfrom the oven cavity. 3. Make sure all oven vents and openingsare clear and are free of any obstruction. IF THEOVENDOESNOT OPERATE: * • • , Checkthat the circuit breakerhas not tripped or the fuse blown. Make sure that the electrical connections havebeen correctly made.