Installation Guide

WARMING DRAWER INSTALLATION GUIDE | 3
3 PRIOR TO INSTALLATION
●
The cavity is square and level, and of the required dimensions.
●
The installation will comply with all clearance requirements and applicable standards and regulations.
●
The power switch will be easily accessible to the customer when the warming drawer is installed.
●
The warming drawer (and any product on top of it) will rest on a surface that can support its weight.
●
The height from the floor suits the customer.
●
You consult local building authorities and by-laws if in doubt regarding installation.
If installing with a companion product
IMPORTANT!
●
If installing with a companion product please refer to the installation instructions of that product to ensure the installation requirements of BOTH products are met.
●
When installing products on top of the warming drawer, the weight of the product should be distributed across the edges of the warming drawer.
●
Products above which rest on ‘feet’ may only be installed if the feet of the product lie within 2 3/4" (70mm) of the sides of the warming drawer, as this area is reinforced.
Failure to do this may result in damage to the warming drawer and companion product.
Screws (4) Anti-tip bracket (1) Oven support brackets (2)
Warming Drawer can withstand
a maximum weight of 132lb (60kg)
2 3/4"
(70mm)
2 3/4"
(70mm)
Feet
A
B
C
D
F
G
H
I
J
K
L
E
2 PARTS SUPPLIED