Installation Guide

WARMING DRAWER INSTALLATION GUIDE | 5
5A CABINETRY DIMENSIONS – UNDERBENCH (ie INSTALLED WITH F&P SINGLE OVEN)
A
B
C
D
F
G
H
I
J
K
L
E
A
B
C
D
F
G
H
I
J
K
L
E
A
B
C
D
F
G
H
I
J
K
L
E
**
28 3/8"
(720mm)
Warming drawer
Warming drawer
Oven
Oven
*PO
Tab
Oven support bracket
Fit the supplied oven support brackets
Unscrew-fit-
rescrew
THE FOLLOWING PAGES DETAIL COMMON CABINETRY SCENARIOS
IMPORTANT!
If installing under an oven, you must first fit the two supplied
Oven support brackets to the sides of the Warming Drawer.
The brackets help support the rear of the oven.
Unscrew the 3 top screws on each side, fit the brackets
with the tabs facing inwards as shown and screw back in.
Note: The screws may not be identical.
Replace each screw into its original hole position.
Oven support
brackets
PLAN
SIDE
CABINETRY DIMENSIONS inches (mm)
M
Minimum inside height of cavity 27" (687)
N
Inside width of cavity 22" (560)
O
Minimum inside depth of cavity 22 1/4" (565)
Note: When installed in combination with a companion product the companion product may be placed directly onto the warming drawer. It is not
necessary to place a shelf between the products. A built-in shelf at the base of the cabinetry able to support the weight of both products is required.
* PO – POWER OUTLET. Ensure there is an accessible earthed power outlet within 35 7/16" (900mm) of the centre rear of the product.
N
O
M