Kick Strip Attachment Instructions

1 Align the brackets to the mounting
holes located along the tabs at the
top and bottom of the inner panel.
Ensure brackets are
correctly oriented.
2 Secure each bracket to the panel via
the mounting holes using four screws
per bracket as shown.
3 Slot the kick-strip cover over the
outside of the inner panel.
5
Align the as
sembled kick-strip panel with the range
feet and push firmly to clip into place.
591555A / 1105688-ß0 11.17
4 Adjust the height of the kick-strip cover to suit the
height of the feet on your range. Secure at either
end of the kick-strip.
INSTALLATION INSTRUCTIONS
Keep this document handy for easy reference.

For detailed information on the features of your product, see your ‘User guide’,
paying special attention to the ‘Safety and warnings’ section.

For contact information or if you require service, assistance or replacement parts,
see your ‘Service & warranty’ booklet or visit fisherpaykel.com
PRODUCT COMPATIBILITY:
OR30S models
Features may vary
OR36S models
OR90S models
US CA NZ AU GB IE
FREESTANDING RANGE - KICK-STRIP ATTACHMENT
INSTALLATION GUIDE
SAFETY AND WARNINGS
WARNING!
Cut hazard
Take care - panel edges are sharp.
Failure to use caution could result in injury or cuts.