Installation Guide
Table Of Contents
- Safety and warnings
- General installation information
- Parts supplied for installation
- Tools needed for installation (not supplied with the appliance)
- Model identification
- Prior to installation
- Product dimensions
- Clearance dimensions
- Fitting the optional backguard
- Location of electrical supply
- Ventilation requirements
- Fitting the adjustable feet
- Moving the range
- Installing the anti-tip bracket
- Electrical connection
- Connection of the power supply cable
- Gas connection
- Flame testing
- Leak testing
- Gas conversion
- Adjusting the minimum burner settings
- Final checklist
12
dotted line showing the
position of the range
when installed
40mm
min 167mm
max 217mm
IMPORTANT!
To restrain the range and prevent it tipping accidentally secure the
range to the wall using the supplied anti-tip bracket. Ensure you also
fit the supplied lock pin to the anti-tip bracket.
If installing the range above a plinth (without fitting the
adjustable feet) revise the installation dimensions for the anti-tip
bracket accordingly, considering that the feet have the following
measurements: min 85mm – max 133mm.
Before drilling and holes or inserting any screws into the floor or wall
check that you will not damage any wiring or pipes.
To fit the anti-tip bracket
1 Loosely fix the anti-tip bracket to the wall using the supplied screws.
z
Drill two 8mm diameter holes in the wall and insert the supplied
plastic sleeve anchors before inserting the screws.
2 Slide the range into place and adjust the height of the bracket so
that it will align with the slot on the back of the range.
3 Tighten the screws to fix the anti-tilt bracket in place.
4 Push the range back into place so that the bracket is fully inserted
into the slot on the back of the range.
INSTALLING THE ANTI-TIP BRACKET
anti-tip bracket
bracket
slot at
back of
the range