Installation Guide
Table Of Contents
- Safety and warnings
- General installation information
- Parts supplied for installation
- Tools needed for installation (not supplied with the appliance)
- Model identification
- Prior to installation
- Product dimensions
- Clearance dimensions
- Fitting the optional backguard
- Location of electrical supply
- Ventilation requirements
- Fitting the adjustable feet
- Moving the range
- Installing the anti-tip bracket
- Electrical connection
- Connection of the power supply cable
- Gas connection
- Flame testing
- Leak testing
- Gas conversion
- Adjusting the minimum burner settings
- Final checklist
14
IMPORTANT!
z
This range must be connected to the mains power supply only
by a suitably qualified person. This range must be earthed.
z
If the installation requires alterations to the domestic electrical system, call a qualified electrician. The electrician should also check
that the electrical system is suitable for the electricity drawn by the cooker.
z
The appliance must be connected to the mains electricity supply, checking that the voltage corresponds to the value given in the
rating plate and that the electrical cable sections can withstand the load specified on the plate.
z
A suitable disconnection switch must be incorporated in the permanent wiring, mounted and positioned to comply with the local
wiring rules and regulations. The switch must be of an approved type installed in the fixed wiring and provide a 3mm air gap
contact separation in all poles in accordance with the local wiring rules.
z
A switch of the approved type with a 3mm air gap must be installed in the active (phase) conductor of the fixed wiring.
z
The switch must always be accessible.
z
The power supply cable must not touch any hot parts and must be positioned so that it does not exceed 75°C at any point.
z
This cooker must be connected to a suitable double pole control unit adjacent to the cooker. No diversity can be applied to
this control unit.
z
This appliance must be connected to the electrical supply using a cable fitted with an appropriately rated plug. The plug must be
compatible with the socket-outlet fitted to the final subcircuit in the fixed wiring that is intended to supply the appliance.
Replacing the power cord
z
Replacements should only be made by a qualified electrician.
z
Use a cable according to the applicable local regulations.
MODEL CODE MAX POWER (W) HZ VOLTAGE (V) AMPS (A)
OR90SCG1 3210 50 Hz 220 – 240V~ 13.95
OR90SCG2 4950 50 Hz 220 – 240 V~ 21.54
OR90SCG4 4950 50 Hz 220 – 240 V~ 21.54
OR90SCG6 5200 50 Hz 220 – 240 V~ 22.60
OR90SDG6 5200 50 Hz 220 – 240 V~ 22.60
ELECTRICAL CONNECTION
location of
nameplate