User Guide
Table Of Contents
- User Guide
- Contents
- Safety and warnings
- Introduction
- First use
- Cooking guide
- Oven functions
- Cooking charts
- Setting the timer
- Auto Cook
- Using your induction cooktop
- Using your cooktop’s special features
- Choosing the right cookware
- Cooking guidelines
- Using the storage compartment
- Care and cleaning
- Troubleshooting
- Alert codes
- Warranty and service
33
USING YOUR INDUCTION COOKTOP
If a display flashes alternately with the heat setting
This means that:
z
you have not placed a pan on the correct cooking zone or
z
the pan you’re using is not suitable for induction cooking or
z
the pan is too small or not properly centred on the
cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone. The cooktop will
automatically turn off after 10 minutes if no suitable pan is placed on it.
IMPORTANT!
The whole of the cooking zone is activated when a pot is detected. This means that other
magnetisable items (such as cutlery) sitting in the cooking zone will heat up.
Never leave cutlery or other magnestisable items on your cooktop.
Locking the cooktop
z
You can lock the cooktop control dials for cleaning and to prevent unintended use.
(for example children accidentally turning cooking zones on).
z
When the cooktop is locked the controls and cooktop display will remain unresponsive.
To lock the cooktop
1 Make sure that all cooking zones are turned OFF.
2 Turn the control dials for the two left cooking zones anticlockwise to
.
3 Hold the dials at
until appears in the cooktop display.
To unlock the cooktop
z
Repeat the steps above.
z
Hold the dials at until disappears from the cooktop display.
Your cooktop is now ready to be used again.