COMBINATION STEAM OVEN PROFESSIONAL OS30NPX1 models INSTALLATION GUIDE US CA
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electrical shock or death. • Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains electricity supply. General z z z z z z z • Connection to a good ground wiring system is absolutely essential and mandatory. • Alterations to the domestic wiring system must only be made by a qualified electrician.
INSTALLATION CONSIDERATIONS COMPONENTS REQUIRED PRIOR TO INSTALLATION Prior to installing your oven, ensure the following: z z z z z z z z z The countertop and oven cavity are square and level, and are the required dimensions. The installation will comply with all clearance requirements and applicable standards and regulations. The isolating switch will be easily accessible to the customer with the oven installed.
PRODUCT DIMENSIONS E F PRODUCT DIMENSIONS IN MM 18 1/2 470 29 13/16 757 C Overall depth (excluding handles and dials) 22 5/16 567 D Height of chassis 17 9/16 446 E Width of chassis 25 3/8 645 F Depth of chassis 20 13/16 528 1 9/16 39 9/16 14 3/8 10 12 1/8 308 A Overall height B Overall width PLAN ISOMETRIC C G Depth of oven frame and control panel (distance between front of chassis and front of oven door, excl.
CABINETRY DIMENSIONS (FLUSH INSTALL) B Ventilation of 2" x 22 1/16" (50x560mm) or totalling 43.4in2 (280cm2) is required for companion products. The air vent must be located at the rear of cabinet, it can be positioned at the base, top, sides, or back of the cavity.
CABINETRY DIMENSIONS (PROUD INSTALL) B Ventilation of 2" x 22 1/16" (50x560mm) or totalling 43.4in2 (280cm2) is required for companion products. The air vent must be located at the rear of cabinet, it can be positioned at the base, top, sides, or back of the cavity.
ELECTRICAL CONNECTION SECURE THE OVEN TO THE CABINETRY Before connecting the oven to the mains power supply, check that: z z specifications of the electrical system match with what is detailed on this section. system has an effective ground connection compliant with current standards and laws. The ground connection is required by law. The cable must not, at any point, reach a temperature greater than 122°F (50°C) above room temperature.
ATTACH THE LOWER TRIM TO THE OVEN Attach the lower trim to the oven after installing the oven in the cabinetry. 1 Align the lower trim with the tabs on the base of the oven. Use the supplied screws to attach the lower trim to the tabs. 2 Take care not to bend the tabs while installing. Do not over-tighten the screws.
INSTALLER CHECKLIST TO BE COMPLETED BY THE INSTALLER Make sure the oven is level and securely fitted to the cabinetry. Turn the power to the oven on. The display should turn on.. Check the lower trim is correctly attached and undamaged. Have you demonstrated basic operation to the customer? Ensure the oven door opens fully without obstruction. Open the oven door slowly until it is fully open and check there is adequate clearance between the bottom of the door and the lower trim.
FISHERPAYKEL.COM © Fisher & Paykel Appliances 2021. All rights reserved. The models shown in this guide may not be available in all markets and are subject to change at any time. The product specifications in this guide apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.
