Installation Guide

7
UL - listed conduit
connector
wall wiring
box
cable from
power supply
white wires
red wires
green grounding
oven wires -
factory taped
black wires
z
Do not lift the oven by the door handle.
z
Do not over-tighten the screws.
z
Do not seal the oven into the cabinetry with silicone or glue. This makes future servicing
difficult. Fisher & Paykel will not cover the costs of removing the oven, or of damage
caused by this removal.
z
Take care not to bend the tabs for the lower trim while installing the oven.
1 Position the oven in the prepared cavity. Make sure the oven is centered and level.
2 Open the oven door fully.
3 Mark and pre-drill the screw holes.
4 Place the supplied washers onto the mounting screws, then use to secure the oven to
the cabinetry.
SECURE THE OVEN TO THE CABINETRYELECTRICAL CONNECTION
Before connecting the oven to the mains power supply, check that:
z
specifications of the electrical system match with what is detailed on this section.
z
system has an effective ground connection compliant with current standards and laws.
The ground connection is required by law. The cable must not, at any point, reach a
temperature greater than 122°F (50°C) above room temperature.
This oven must be connected to the electricity through a power supply cable and plug
that is compatible with the outlet of the electrical system that powers this oven. If a
fixed appliance does not have a power cord and plug, or another device that ensures
disconnection from the mains, with an opening distance of the contacts that allows complete
disconnection, such disconnection devices must be provided in the power supply mains
conforming to the installation rules.
The omnipolar socket or switch must be easy to reach when the appliance is installed.
Note: The manufacturer declines all liability if the usual accident prevention standards and
the above instructions are not followed.
MAX POWER (W) HZ VOLTAGE (V) AMPS (A)
3000 60 Hz 240V 12.5
2250 60 Hz 208V 10.8