Installation Guide

13
!3 INSTALL CABINETRY ATTACHMENT BRACKETS
Adjust the air flow stops
4 Adjust the air flow stops located on the back cover of the compressor. Ensure the air flow
stops make contact with the cabinetry.
IMPORTANT!
It is possible for the air flow stops to get flattened during transport. If this happens,
unfurl the air flow stops to ensure they meet the back of the cabinetry to help airflow.
Adjust the air flow stops
Air flow
stops
Air
outlet
Air inlet
Install cabinetry attachment bracket to the appliance
1 Remove the pre-existing screw/plastic
washer(A) and plastic plugs (B) on
the non-hinge side bottomcorner of
the appliance.
2 Attach the position adjustment plate (C)
to the cabinetry attachment bracket (D)
by inserting the knobs of the plate into
the holes of the bracket.
3 Install the cabinetry attachment bracket
to the bottom non-hinge side of the
appliance by inserting two screws (E)
into the existing plug holes.
– Do not tighten fully to allow for
adjustment.
C
D
A
B
Loosely screw in, to enable
bracket to slide side to side
E