Installation Guide

Table Of Contents

!8 INSTALL DOOR PANELS (STAINLESS STEEL)

Fixing the top door panel

!6 Once you are satisfied with the adjustment, fully tighten the screws of the bottom

attachment brackets (K) to secure the door panel.

Repeat step

for the door panel of freezer door.

Height adjustment of the door panel

!1 Turn the height adjustment nuts (H) with a hexkey. Hold the side adjustment nuts (J) in

place with a spannerto ensure it does not rotate when turning the height adjustment nuts.

– We recommend to use a T-handle hex key so that the height adjustment nuts can be

turned easily without being blocked by the magnet sensor.

– If the height adjustment nuts cannot be adjusted, check the left and right clearances

ofthe top hanging bracket.

Side adjustment of the door panel

!2 Move the door panel slightly sideways to adjust the side alignment.

!3 Screw the side adjustment nuts (I) onto the thread of the height adjustment nuts to secure

the door panel to the refrigerator door.

Depth adjustment of the door panel

!4 Loosen the depth adjustment nuts (J) and move the door panel forward/backward to

adjust the depth position.

!5 Tighten the nuts fully after you are satisfied with the adjustments.

Repeat steps

–

for the door panel of freezer door.

Note: The magnet sensor is installed only on the refrigerator door.

Adjusting the door panel

SCALE 2:1