Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Components list
- 3 Components list — Door panels and handles
- 4 Product dimensions
- 5 Cabinetry dimensions
- 6 Door opening rotation
- 7 Electrical specifications
- 8 Before installation
- 9 Unpacking and moving your product
- 10 Installation overview
- 11 Changing over door hinge (optional)
- 12 Install trim clips
- 13 Install cabinetry attachment brackets
- 14 Install clearance adjustment plates
- 15 Position your product inside the cabinetry
- 16 Fix your product inside the cabinetry
- 17 Install the trims
- 18 Install door panels (stainless steel)
- 19 Install top door panel (custom)
- 20 Install bottom door panel (custom)
- 21 Install covers and inlet vent grille
- 22 Final checklist
18
!8 INSTALL DOOR PANELS (STAINLESS STEEL)
IMPORTANT!
Ensure to protect the finish of the Fisher & Paykel Stainless steel door panels.
Leave the protective film on the panels when hanging and remove the film only when the installation is complete.
Removing the hanging bracket
1 Open the refrigerator door and remove the top hanging bracket cover by drawing out
upwards.
Refrigerator door
Repeat steps 1 – 2 for the freezer door.
2 Remove the two side adjustment nuts (A) on the top hanging bracket using a spanner,
then remove the top hanging bracket and rulers together.
– Keep the hanging bracket to reinstalllater.
Refrigerator door
Top hanging
bracket
A