Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Components list
- 3 Components list — Door panels and handles
- 4 Product dimensions
- 5 Cabinetry dimensions
- 6 Door opening rotation
- 7 Electrical specifications
- 8 Before installation
- 9 Unpacking and moving your product
- 10 Installation overview
- 11 Changing over door hinge (optional)
- 12 Install trim clips
- 13 Install cabinetry attachment brackets
- 14 Install clearance adjustment plates
- 15 Position your product inside the cabinetry
- 16 Fix your product inside the cabinetry
- 17 Install the trims
- 18 Install door panels (stainless steel)
- 19 Install top door panel (custom)
- 20 Install bottom door panel (custom)
- 21 Install covers and inlet vent grille
- 22 Final checklist
19
!8 INSTALL DOOR PANELS (STAINLESS STEEL)
Installing the hanging and attachment brackets
3 Remove the rulers (B) from the top hanging
bracket and discard.
4 Align the screw holes of the top
hanging bracket with the screw holes of
the top door panel and fix the bracket
with supplied M5x12 screws (C).
5 Align the screw holes of the bottom
attachment bracket assembly (Bottom
attachment bracket, Side spacer
bracket, Bottom attachment strap) with
the screw holes of the top door panel,
and fix with M5x12 screws (D).
Attaching the door handle
6 Remove the plastic plugs from handle
holes (4x).
7 Align the handle to the holes and secure
with M5x25 hex screws (E).
E
C
Repeat steps 3 – 7 for the door panel
of freezer door.
D
B
Repeat steps 8 – !0 for the door panel of freezer door.
Note: The magnet sensor is installed only on the refrigerator door.
Hanging the door panel
8 Open the refrigerator door.
9 Hang the top door panel onto the height
adjustment nuts (F) at the top of the
refrigerator door.
F
Bottom view of door
!0 Align the bottom attachment
brackets with screw holes at the
bottom of the top door panel.
Fasten with bottom attachment
screws (G).
– Do not tighten fully to
allow adjustment of the
top door panel.
G