Installation Guide

21
!9 INSTALL TOP DOOR PANEL (CUSTOM)
Removing the hanging bracket
Refrigerator door
2 Pull out the rulers from the
internal slots of the top
hanging bracket and turn the
rulers around.
3 Insert the rulers into the
external slots of the top
hanging bracket with the
overhang of the rulers
pointing outward.
External slots
Internal slots
5 Remove the two side adjustment
nuts (C) on the top hanging bracket
using a spanner, then remove the top
hanging bracket and rulers together.
– Ensure the rulers are kept
in place as you remove the
hanging bracket.
– Keep the hanging bracket to
reinstalllater.
Refrigerator door
C
Note:

If there is an existing
compartment on top of the
cabinetry, push the rulers so
that the overhang of each
ruler contacts the bottom of
compartment front panel (B).

The overhang creates a 1/8”
(3mm) gap between top and
bottom door panels.
4 Push the rulers down so that
the underside of the overhang
of the ruler is flush with the
top of the cabinetry (A).
1/8” (3mm) gap
Compartment
front panel
B
Side view
Side view
Flush
A
Top of cabinetry
Ruler
Top hanging
bracket
1 Open the refrigerator door and
remove the top hanging bracket
cover by drawing out upwards.