Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Components list
- 3 Components list — Door panels and handles
- 4 Product dimensions
- 5 Cabinetry dimensions
- 6 Door opening rotation
- 7 Electrical specifications
- 8 Before installation
- 9 Unpacking and moving your product
- 10 Installation overview
- 11 Changing over door hinge (optional)
- 12 Install trim clips
- 13 Install cabinetry attachment brackets
- 14 Install clearance adjustment plates
- 15 Position your product inside the cabinetry
- 16 Fix your product inside the cabinetry
- 17 Install the trims
- 18 Install door panels (stainless steel)
- 19 Install top door panel (custom)
- 20 Install bottom door panel (custom)
- 21 Install covers and inlet vent grille
- 22 Final checklist
25
@0 INSTALL BOTTOM DOOR PANEL (CUSTOM)
Installing the hanging and attachment brackets
7 Align the center line of the top hanging
bracket with the center of the top door panel.
8 Once aligned, fix the top hanging bracket to
the bottom door panel with wood screws.
9 Remove the rulers from the top hanging
bracket and discard.
Hanging the door panel
!0 Open the freezer door.
!1 Hang the bottom door panel onto the
height adjustment nuts (D) at the top
of the freezer door.
!2 Align the bottom attachment
brackets (E) with the screw
holes at the bottom of the
bottom door panel. Fasten with
cabinetry attachment screws (F)
and wood screws (G).
– Do not tighten fully to
allow adjustment of the
bottom door panel.
Bottom view of door
D
E
F
G
C
6 Lay the bottom custom door panel
(face down) onto the floor and place
the top hanging bracket on the door
panel. Latch the rulers on top of the
door panel (C).