Installation Guide
9
9 UNPACKING AND MOVING YOUR PRODUCT
WARNING!
Follow these instructions to avoid risks that can cause serious injury or death.
Keep doors closed until the product has been moved to its installation location.
IMPORTANT!
Be careful when unpacking to prevent damage to the surface of your product.
Ensure that the product is stable to prevent from tipping over when unpacking.
Do not open the doors to prevent the product from tipping over.
If the product is damaged, contact your Fisher & Paykel dealer.
Take note of your model and registration numbers located at the bottom right side of the
product. You will need these to request for servicing or repair of your product.
4 Remove the door gasket
baffles from both doors (A).
– Keep the door gasket
baffles in case you need
to move the product in
the future.
B
D
C
Top and side trims
Unpacking your product
1 Remove the carton and packaging,
along with the rip tag.
2 Remove the side trims taped to the
side of the product and the top trim
from inside theproduct.
3 Remove the bags of component parts
from inside the product.
Door gasket baffle
A
Moving your product
5 After unpacking, tape the door shut to prevent the possible opening of the doors when tilting.
6 Tilt the product slightly forward (B) and slide a two-wheeled cart (C) between the product
andbase pack (polystyrene foam).
– Do not insert the cart from the back or front side of the product!
7 Restrain the product to the cart with straps, and then tilt backward onto the cart (D).
8 Set aside the base pack and push the product to the installation location.
– Make sure the door stays closed until the product is positioned inside the cabinetry.