Installation Guide

18
!8 INSTALL DOOR PANELS (STAINLESS STEEL)
IMPORTANT!

Ensure to protect the finish of the Fisher & Paykel Stainless steel door panels.

Leave the protective film on the panels when hanging and remove the film only when the installation is complete.
Loosening the height adjustment nut
Before installing the top door panel, you must
remove the door magnet from the refrigerator
door to enable you to access and loosen the
height adjustment nut.
4 Loosen the height adjustment nut (D) with
a spanner.
IMPORTANT!
Do not remove!
Note: Loosening the nut allows you to
easily turn it from the top using a hex key
after the door panel has been installed.
5 Reinstall the sensor magnet to the refrigerator
door (E) and then close the door.
IMPORTANT!

Reinstall the door sensor magnet before
fitting the door panel as this is not possible
once the door panel is installed.

The magnet sensor is installed only on the
refrigerator door.
3 Remove the magnet (B) by unscrewing the
screws (C) using a crosshead screwdriver.
IMPORTANT!
Keep the sensor magnet to reinstall later.
B
E
C
C
D
Removing the hanging bracket
1 Open the refrigerator door and remove the top
hanging bracket cover by drawing out upwards.
Refrigerator door
Repeat steps 1 – 2 for the freezer door.
2 Remove the two side adjustment
nuts (A) on the top hanging bracket
using a spanner, then remove the top
hanging bracket and rulers together.
– Keep the hanging bracket to
reinstalllater.
Refrigerator door
Top hanging
bracket
A