Installation Guide

20
!8 INSTALL DOOR PANELS (STAINLESS STEEL)
Fixing the top door panel
!9
Once you are satisfied with the adjustment, fully tighten the screws of the bottom
attachment brackets (P) to secure the door panel.
Repeat step
!9
for the door panel of freezer door.
Height adjustment of the door panel
!5
Turn the height adjustment nuts (M) with a hexkey. Hold the side adjustment nuts (N) in
place with a spannerto ensure it does not rotate when turning the height adjustment nuts.
– We recommend to use a T-handle hex key so that the height adjustment nuts can be
turned easily without being blocked by the magnet sensor.
– If the height adjustment nuts cannot be adjusted, check the left and right clearances
ofthe top hanging bracket.
Side adjustment of the door panel
!6
Loosen the side adjustment nuts (N) and move the door panel slightly sideways to adjust
the side alignment.
– Hold the height adjustment nuts (M) in place with the hex key to ensure it does not
rotate when loosening the side adjustment nuts.
Depth adjustment of the door panel
!7
Loosen the depth adjustment nuts (O) and move the door panel forward/backward to
adjust the depth position.
!8
Tighten the nuts fully after you are satisfied with the adjustments.
Repeat steps
!5
–
!8
for the door panel of freezer door.
Note: The magnet sensor is installed only on the refrigerator door.
Adjusting the door panel
P
SCALE 2:1
O
M
N