Installation Guide
Table Of Contents
- Contents
- Safety and warnings
- Integrated cooldrawertm
- Supplied parts
- Drawer panels
- Handle kit
- Product dimensions
- Stainless steel panel dimensions
- Custom panel dimensions — Single panel
- Custom panel dimensions — Dual panel
- Cabinetry dimensions — Framed
- Cabinetry dimensions — Frameless
- Electrical connection
- Cabinetry preparation
- Panel preparation
- Attach power cord & trim brackets
- Position product into cabinetry
- Attach drawer panel
- Secure product to cabinetry
- Attach side trims to cabinetry
- Attach false panel
- Final checklist
15
Locate the top attachment hooks (2x)
in correct orientation to the screw
holes at the back of drawer panel*,
and secure with screws.
Tighten the locking screw of each
hook to 5mm depth.
Attach the handle* to the drawer
panel.
Refer to the installation guide included
in your purchased handle kit to attach
the handle.
1
2
3
STAINLESS STEEL PANEL CUSTOM PANEL
PANEL PREPARATION
Refer to the dimensions below for the preparation of the Custom door panel when attaching
the attachment hooks. Drill the screw holes using a 6mm drill bit, and counterbore from the
rear.
Refer to stainless steel panel instructions for securing the attachment hooks to the drawer
panel. Refer to the installation guide included in your purchased handle kit to attach the
handle.
Locate one attachment hook in correct
orientation to the screw hole at
bottom middle of the back of drawer
panel, and secure with screw.
Tighten the locking screw of the hook
to 1mm depth.
bottom attachment hook
top attachment hook
5mm
1mm
*Illustrations showing Professional drawer panel and handle.
2.5mm
19mm
49.5mm
18mm
18mm
min 896mm
min 710mm
18mm
414mm
10-42mm