Installation Guide

4
SAFETY AND WARNINGS
!
WARNING!
Electric Shock Hazard
Failure to follow this advice may result in
electrical shock or death.
• Read and follow the safety and warnings outlined
in this installation guide before operating this
appliance.
!
WARNING!
Cut Hazard
Failure to use caution could result in injury.
• Take care: panel edges may be sharp.
• Do not put fingers in the drawers when closing.
!
WARNING!
Tip Hazard
• Do not operate this appliance until it has been
securely anchored inside the cabinetry.
To ensure that the appliance is stable under
all loading conditions:
• The appliance must be securely anchored to
the floor by a professional installer according
tothe installation steps in this guide.
READ AND SAVE THIS GUIDE
WARNING!
To avoid hazard, follow these instructions carefully before Installing or using thisappliance.
z
Please make this information available to the persons installing the appliance.
z
Assume all electrical parts are live.
z
Disconnect power supply before servicing and installation.
BEFORE INSTALLATION
z
The appliance must be installed by a qualified installer, or Fisher and Paykel trained and
supported service technician to avoid faulty electrical connection.
z
All connections for electrical power and grounding must comply with local codes and
ordinances and be made by licensed personnel when required.
z
Avoid installation of the appliance/s under a ground fault circuit interrupter (GFCI).
z
Ensure the appliance is installed properly. Improper installation that results in appliance
failure is not covered under the appliance warranty.
UNPACKING
z
Remove all packaging materials supplied with the appliance.
z
Avoid scratching the surface of your appliance when moving or installing.
z
If the appliance is damaged, contact your Fisher and Paykel dealer.
z
Ensure all components and accessories are complete.
ELECTRICAL/PLUMBING
z
We recommend to locate the electrical connection of the appliance in an adjacent area or
unit (cabinet or cupboard) that are easily accessible in case of repair or disconnection.
z
Ensure the power outlet is located outside the cavity, within 1850mm from the
CoolDrawer™ cavity if situated on the left-hand side of the cavity, and within 1250mm if
situated on the right-hand side of the cavity.
z
The services hole in the cavity needs to be large enough for the power supply plug to fit
through.
INSTALLATION
z
The installation bracket and fittings supplied must be fitted tothe wall of the finished
enclosure to withstand a 100kg load.
z
Ensure that the installation bracket is installed correctly to prevent the possibility of the
appliance tipping forward when the drawer is open.
z
Ensure the power cord is not run over or damaged when installing the product into
the cabinetry.
z
For flush installation, ensure the drawer panel is installed flush with cabinetry front
surface. Ensure the appliance is properly centered.
z
Complete the final checklist after installation is complete.
z
Protect the finish of the Fisher and Paykel Stainless Steel door panel from any scratch or
damage.
z
If using Custom door panels, ensure they are prepared as per 'Custom door panel install
dimensions' section.
z
The thickness of the custom door panel can vary as long as the screws do not penetrate
beyond the full depth of the door panel, and as long as the overall weight of door panel
does not exceed the allowable weight. Refer to 'Door panel dimensions' for maximum
door panel weight of your product.