Installation Guide

15
All models
IMPORTANT!
z
This range must be connected to the mains power supply only by a suitably
qualified person.
z
This range must be earthed.
z
Always disconnect electric supply cord from the wall outlet or service disconnect
before servicing this appliance.
z
Observe all governing codes and ordinances when grounding, in absence of which,
observe National Electrical Code ANSI/NFPA No. 70.
RDV3 models
z
A neutral supply wire must be provided from the power source (breaker panel)
becausecritical range components, including the surface burner spark reignition module,
require120/240 VAC to operate safely and properly.
z
If the correct power supply circuit is not provided, it is the responsibility and
obligation ofthe installer and user to have proper power supply connected.
Thismustbeaccomplished in accordance with all applicable local codes and ordinances
by a qualifiedelectrician. Itis the responsibility of the installer to ensure compliance
of local codes. In the absence of local codes and ordinances, the power supply
connectionshall be in accordance with the National Electric Code.
z
Observe all governing codes and ordinances when grounding. In the absence of these
codes or ordinances observe National Electrical Code ANSI/NFPA No. 70 current issue.
See the following information in this section for grounding method..
z
The ranges are to be connected to a 240/208 VAC power supply.
IMPORTANT!
z
An improper 120/240 VAC power supply will cause malfunction, damage to this
appliance, and possibly create a condition of shock hazard.
z
Improper connection of aluminium house wiring can result in a fire or shock hazard.
Use only connectors designed and certified for connecting to aluminium wire.
MODEL
MAX.
CURRENTDRAW
CIRCUIT FREQUENCY
RDV3-304 27 A 30 A 60 Hz
RIV3-304 57 A 50 A 60 Hz
RDV3-366 29 A 30 A 60 Hz
RIV3-365 72 A 50 A 60 Hz
RDV3-488 44 A 50 A 60 Hz
RDV3-485GD 44 A 50 A 60 Hz
RHV3-484 75 A 50 A 60 Hz
IMPORTANT!
The fourth prong (round grounding pin) should not, under any circumstances,
becut or removed.
ELECTRICAL CONNECTION
Wiring diagrams are
also in the service
summary, attached
to the inside of the
toe kickpanel
The rating label is
located under the
control panel
A wiring
diagram label
is attached to
the back of
therange