Use & Care Manual

15
INSTALLATION INSTRUCTIONS
EN
!1
Attach double sided foam to the
back of the water filter head as
shown in Diagram5. Write the date
to be replaced on the filter (date
installed +6months). Remove the
double sided foam backing and
attach the filter to the desired
position, reinforcing the filter with
the screws provided as located in
step10 (refer to the previous page).
!2
Run the ¼” (6mm) tubing to the
back of the refrigerator ensuring
there is enough tubing to pull the
refrigerator out for service.
!3
Using the measurement guide
located on the rear compartment
cover as shown in Diagram 6. Mark
out ⅝”(16mm), on the end of the
tubing as shown in Diagram7.
!4
Insert the tubing marked ⅝” (16mm)
into the water (solenoid) valve up
to the marked line as shown in
Diagram8.
!5
Pull gently on tubing to ensure it is
locked in as shown in Diagram9.
!6
The completed installation should
look like Diagram11 on page16.
!7
Turn the isolating faucet on and
check that all connections are dry
and free of drips.
!8
Coil water line tubing behind the
refrigerator. Pushyour refrigerator
into place being careful notto
kink or squash the water line tube
running into the water (solenoid)
valve.
!9
Read pages 16–17 carefully and
then turn refrigeratoron.
Diagram 5
Double sided foam
attachment
Waterline connection to refrigerator
6 7 8 9
DRAWING: 838587
PART: 838587
Diagram 9
Diagram 6
6 7 8 9
DRAWING: 838587
PART: 838587
Diagram 7
6 7 8 9
DRAWING: 838587
PART: 838587
6 7 8 9
DRAWING: 838587
PART: 838587
Diagram 8