Installation Guide

12
!2SECURE SLIDE BRACKET TO CABINETRY DOOR
1 Open both cupboard and refrigerator door to 110°
(525compact models to 90°).
2 Put the slide bracket into the retainer, 120mm (43/4”)
approximately past refrigerator door (A).
3 Check that the screw supplied will not penetrate front surface
ofcupboard door (B).
4 Screw the slide bracket level into the cupboard door.
5 Check the slide mechanism does not bind through swing of door.
6 Repeat the above steps for the second bracket.
IMPORTANT
Ensure that refrigerator doors are able to close fully and seal
around the flexible gasket on the refrigerator/freezer.
This is to prevent air leaks and icing problems.
A
B
Complete Installation
Complete the installation by screwing the
foot integration into position, using screw
supplied with thekit, and the cap elliptical
to cover thescrews.
120mm
(4 3/4”)
Screw slide bracket in level
110°