Installation Guide

15
INSTALLATION INSTRUCTIONS
Installation instructions:
1 Ensure the refrigerator is NOT plugged into
a powersupply.
2 Locate a cold water supply/feed that is
suitable for a water connection.
3 Connect the tap connection fitting (A) to
the tap. Connect the short tubing (B) to
the outlet of the tap and secure with the
locking key (C) (refer to Diagram 1)
4 Connect the inlet of the PLV (D) to the
tubing connected to the tap (refer to
Diagram 2). Ensure the arrow on the PLV
is pointing away from the tap. The arrow
indicates the direction of waterflow.
5 Connect the inlet tube from the filter head
to the PLV (refer to Diagram 3). The inlet
tube can be identified by the downward
arrow
on the filter head and a red
mark on the tube.
Ensure the outlet tubing is correctly
connected to the refrigerator water valve.
Refer to Diagram 3.
6 Determine the mounting position for the
water filter noting the following:
z
The water filter MUST not be mounted
with the filter head position below the
base of the filter (refer to Diagram 4). We
recommend fitting the water filter in a
vertical orientation with the filter head at
the top. This will minimise water leakage
during replacement of the waterfilter.
z
Ensure the water filter is in a convenient
location to access every 6months for
replacement. We recommend that this
location is beside the water filter supply tap
in a cupboard beside the refrigerator.
z
A minimum clearance of 50mm from the
bottom of the water filter is required to
perform filter removal.
Diagram 1
Diagram 2
Diagram 3
0° – 90°
Diagram 4
Inlet
tube
water flow
from PLV
water flow to
refrigerator
INSTALLATION INSTRUCTIONS