Installation Guide

10
BEFORE INSTALLATION ELECTRICAL CONNECTION
Please follow the installation steps below to ensure your appliance operates correctly.
Power
z
Install your appliance where the plug is easily accessible.
z
Connect your refrigerator to a separate power point. Avoid sharing the power point with
other appliances. Do not use extension cords and double adaptors as the combined
weight of two power cords can pull the double adaptor from the power outlet.
z
For power requirements, refer to the information on the serial plate located at the front
bottom right-hand side of the refrigerator when the door is open.
z
Ensure your appliance is properly grounded (earthed).
z
Connect the appliance to the electrical supply (220V – 240V 50Hz) with the fitted plug
and lead.
z
Connections to the mains supply should be in accordance with local regulations.
Ice & Water and Automatic Ice models
z
Your Ice & Water and Automatic Ice refrigerator must be installed by a qualified plumber
or Fisher&Paykel trained and supported service technician as incorrect plumbing can
lead to water leaks.
z
Fisher&Paykel Appliances does not accept responsibility for damage (including water
damage) caused by faulty installation or plumbing.
Alternative locations for
connection at rear of cavity
Electrical connection
must be within this space
if located behind the
appliance and must not
protrude from the back wall.
ELECTRICAL SPECIFICATIONS
Supply 230 VAC, 50 Hz
Service 10 amp circuit
Socket 3-pin earthing-type
We recommend the use of an isolating switch that is easily accessible to the user after the
refrigerator is installed.