Installation Guide
Table Of Contents
- Introduction
- Safety and warnings
- ActiveSmart™ special features
- ActiveSmart™ operating instructions
- Humidity control system
- Door alarms
- Alarm Mute
- Key Mute
- Key Lock
- Sabbath mode activation
- Using your water dispenser (Water dispensing models only)
- Water filter (Ice & Water and Automatic Ice models only)
- Using your ice maker (Ice & Water and Automatic Ice models only)
- Bottle Chill
- Fast Freeze
- Ice boost function
- Manual ice system (selected models only)
- Humidity control system
- Cleaning and care
- Foodcare
- Moving or storing your appliance
- ActiveSmart™ sounds
- Troubleshooting
- Manufacturer’s Service & Warranty
- European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)
34
Drip tray
(Water dispensing models only)
The drip tray is designed to fit into the
bottom of the water dispenser panel.
To insert the tray ensure the
rounded sides are fitted into the
dispenser panel first.
The purpose of the tray is to
capture drips of water that may fall
after dispensing.
The tray can be removed for cleaning.
ACTIVESMART™ OPERATING INSTRUCTIONS
Drip tray
Glass shelves – Freezer
Some models have glass shelving under the freezer bins. These can be
removed if required.
To remove
1
Remove the bin above the glass shelf (refer to ‘Fixed bins’)
2
Push on the clips below the bin runners on both sides of the shelf (A)
3
Lift the shelf up to remove from the supports
A