Installation Guide

12
FLUSHING THE WATER FILTER (ICE & WATER MODELS)
There may be a few drips of water coming out of the dispenser for a few days after
installation. This is normal and occurs as the remaining trapped air is cleared from the sytem.
Ensure your refrigerator has cooled for at least 2hours beforeuse.
To turn your ice maker on press .
The light above the button
will illuminate.
Press the
, and together for 4
seconds then close the doors. The ice
tray will empty the water into the bin
below. The ice tray will only empty after
the doors are closed.
Repeat to remove dust in the ice
tray collected during manufacture
and transport.
Empty the water, dry the bin and return
it correctly.
Once your ice maker is turned on the first bin of ice may be discoloured. This is not harmful
and normal during the flushing process. Discard the first full bin of ice made. Your ice maker is
now ready for use.
The performance of your water filter will increase with use, reaching optimum performance
after two to three full bins of ice.
Carry out the above steps after a holiday/vacation or extended periods of not using ice.
1
2
3
1 Press the water dispenser pad to
dispense 4L of water. Wait for 4minutes
before dispensing again.
2 Dispense 4L of water and then wait for
another 4minutes. There may be carbon
residue dispensed together with water.
This is not harmful, and is normal during
the flushing process.
3 Dispense another 4L of water. This
prevents excessive dripping of water from
your dispenser.
FLUSHING THROUGH THE WATER DISPENSER FLUSHING THROUGH THE AUTOMATIC ICE MAKER