Quick Start Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
22
!5SINGLE INSTALLATION
2 Continue turning the adjusting screws alternately between front and rear feet until
you achieve the correct alignment.
3 Once you are satisfied with the alignment, raise the height of the appliance by
alternately adjusting the front and rear feet until the top surface contacts the
alcove ceiling.
Check the alignment gauges while adjusting the screws to make sure you
maintain the alignment of the appliance.
4 Ensure all feet are positively engaged with the floor.
Rear footFront foot
A
Front foot
adjustment
Rear foot
adjustment
Adjusting height of the appliance inside the cabinetry
IMPORTANT!
Ensure the doors are in line with the cabinetry front and the appliance is centered.
All four corners of the appliance must be supported firmly onto the floor to
eliminate any movement. Installing the appliance on a soft, uneven, or not level
floor may cause twisting and poor door sealing.
Required components/tools:
Phillips screwdriver or power driver (PH2 bit) at minimum torque setting
1 Fix each top bracket to the ceiling
surface with two 8Gx16 countersunk
screws (B).
– 18” (457mm) column = 1 bracket
– 24” (610mm) column = 2 brackets
– 30” (762mm) column = 2 brackets
Note: Make sure the appliance does not
move as you open the door when you
install the screws.
B B
C C
B
C
IMPORTANT!
Make sure to remove the depth alignment brackets before fixing the appliance inside
the cabinetry.
Open the appliance door to remove the alignment brackets from both sides of the
appliance, and then re-tighten the screws.
Required components/tools:
Phillips screwdriver or power driver
6x 8Gx16 countersunk screws (840597)
2 Fix the alcove side brackets (1x per
each side) to the alcove side surface
with 8Gx16 countersunk screws (C).
Fixing the appliance inside the cabinetry
1 Turn the front and rear adjustment
screws using a Phillips screwdriver
(or powered driver) to extend the
feet until it engages the floor.
– One turn of height adjusting
nuts is equivalent to 1/32”
(0.5mm) of height adjustment.
Clockwise turn raises the height
and counter-clockwise turn
lowers height (A).