Installation Guide
Table Of Contents
- Safety and warnings
- Integrated refrigerator & freezer
- Integrated refrigerator-freezer
- Integrated wine cabinet
- Supplied parts
- Required parts
- Door panel kit
- Handle kit
- Hinge change kit
- Wine display accessories
- Tools
- Product dimensions
- Cabinetry dimensions — Single installation
- Cabinetry dimensions — Multiple installation
- Stainless steel Door panel dimensions — Single installation
- Custom Door panel dimensions — Single installation
- Custom Door panel dimensions — Multiple installation
- Toe kick dimensions
- Installation options
- Door clearance
- Drawer clearance
- Electrical and plumbing
- Custom door panel install dimensions
- Before installation
- Cavity preparation
- Appliance preparation
- Door panel preparation — Stainless steel panel
- Door panel preparation — Custom panel
- Door panel preparation — Wine cabinet only
- Power and water supply connection
- Install water filter
- Single installation — Align appliance into cabinetry
- Single installation — Secure appliance into cabinetry
- door panel installation
- Toe kick installation
- Grilles installation
- Carbon filter installation
- Air flow divider installation
- Cabinet trims installation
- Top trim & hinge pocket covers installation
- Multiple installation — Appliance preparation
- Multiple installation — Align first appliance into cabinetry
- Multiple installation — Secure first appliance into cabinetry
- Multiple installation — Align second appliance into cabinetry
- Multiple installation — Secure second appliance into cabinetry
- Multiple installation — Install cabinet trims
- Wine display for Wine cabinet (optional)
- Change the door hinges (optional)
- Final checklist
39
Roll the appliance carefully into the cabinetry until the anti-tip bracket overlaps the
back edge of the appliance.
z
Ensure the bracket overlaps the appliance by a minimum 7 1/16" (180mm) for a
secure hold.
z
Be careful not to run over the water hose and power cord when rolling in
the appliance.
SINGLE INSTALLATION — ALIGN APPLIANCE INTO CABINETRY
Pushing into the cabinetry
Aligning the depth gauges
NO FILL NO FILL NO FILLFILL
Tools
Cross-head
screwdriver
Ruler
Pencil
Check if the gaps between appliance and cabinetry side walls are
even on left and right sides.
On the 'Cabinet depth alignment' side of the depth gauges, mark the step on both
sides of the door based on the thickness of the door panel.
z
Example illustration show the door panel thickness 1" (25.4mm) marked on the
gauges.
Left
Right
7 1/16" (180mm)
Illustrations may differ from your purchased appliance.