Installation Guide
Table Of Contents
- Safety and warnings
- Integrated refrigerator & freezer
- Integrated refrigerator-freezer
- Integrated wine cabinet
- Supplied parts
- Required parts
- Door panel kit
- Handle kit
- Hinge change kit
- Wine display accessories
- Tools
- Product dimensions
- Cabinetry dimensions — Single installation
- Cabinetry dimensions — Multiple installation
- Stainless steel Door panel dimensions — Single installation
- Custom Door panel dimensions — Single installation
- Custom Door panel dimensions — Multiple installation
- Toe kick dimensions
- Installation options
- Door clearance
- Drawer clearance
- Electrical and plumbing
- Custom door panel install dimensions
- Before installation
- Cavity preparation
- Appliance preparation
- Door panel preparation — Stainless steel panel
- Door panel preparation — Custom panel
- Door panel preparation — Wine cabinet only
- Power and water supply connection
- Install water filter
- Single installation — Align appliance into cabinetry
- Single installation — Secure appliance into cabinetry
- door panel installation
- Toe kick installation
- Grilles installation
- Carbon filter installation
- Air flow divider installation
- Cabinet trims installation
- Top trim & hinge pocket covers installation
- Multiple installation — Appliance preparation
- Multiple installation — Align first appliance into cabinetry
- Multiple installation — Secure first appliance into cabinetry
- Multiple installation — Align second appliance into cabinetry
- Multiple installation — Secure second appliance into cabinetry
- Multiple installation — Install cabinet trims
- Wine display for Wine cabinet (optional)
- Change the door hinges (optional)
- Final checklist
57
Handle assembly
Retainer blocks are pre-assembled at the bottom of both ends of the handle.
Cradle assembly
A retainer block is pre-assembled at the bottom of each cradle. Use a spacer to correctly
position the cradle and avoid wine bottles being too upright resulting in bottles tipping over.
Align handle to the front end of
display rack.
2
Insert retainer block at desired
location between slats of display
rack. Do not tighten.
1
Place ‘cradle guide’ on the slats
behind the handle..
Align cradle on spacer based on
size and type of wine bottle.
2
Rotate the retainer block to lock
position, and tighten screw.
Remove cradle guide from the rack
after use.
3
Loosen the screws until the
retainer blocks can be inserted
between slats of display rack.
1
Rotate retainer block to lock
position and tighten screw to lock
handle in place.
3
Write the name or type of wine on
the label.
Wine label kit
1
Fit label over front edge of rack to
match displayed wine.
2
Wipe the labels with a damp cloth
to erase.
3
WINE DISPLAY FOR WINE CABINET (OPTIONAL)