Installation Guide
Table Of Contents
- Safety and warnings
- Integrated refrigerator & freezer
- Integrated refrigerator-freezer
- Integrated wine cabinet
- Supplied parts
- Required parts
- Door panel kit
- Handle kit
- Hinge change kit
- Wine display accessories
- Tools
- Product dimensions
- Cabinetry dimensions — Single installation
- Cabinetry dimensions — Multiple installation
- Stainless steel Door panel dimensions — Single installation
- Custom Door panel dimensions — Single installation
- Custom Door panel dimensions — Multiple installation
- Toe kick dimensions
- Installation options
- Door clearance
- Drawer clearance
- Electrical and plumbing
- Custom door panel install dimensions
- Before installation
- Cavity preparation
- Appliance preparation
- Door panel preparation — Stainless steel panel
- Door panel preparation — Custom panel
- Door panel preparation — Wine cabinet only
- Power and water supply connection
- Install water filter
- Single installation — Align appliance into cabinetry
- Single installation — Secure appliance into cabinetry
- door panel installation
- Toe kick installation
- Grilles installation
- Carbon filter installation
- Air flow divider installation
- Cabinet trims installation
- Top trim & hinge pocket covers installation
- Multiple installation — Appliance preparation
- Multiple installation — Align first appliance into cabinetry
- Multiple installation — Secure first appliance into cabinetry
- Multiple installation — Align second appliance into cabinetry
- Multiple installation — Secure second appliance into cabinetry
- Multiple installation — Install cabinet trims
- Wine display for Wine cabinet (optional)
- Change the door hinges (optional)
- Final checklist
60
F
Unclip the hall sensor
from the housing.
Move the sensor housing
to align the opposite hall
sensor clip with the centre
of the cabinet.
Unhook the interceptor
board harness from
sensor housing so
harness is loose.
Reinstall the sensor housing
using #8x16 screws (2x)
into the pre-drilled holes in
the cabinet top panel.
Clip the hall sensor into
the sensor housing in
the pocket closest to the
centreline of the cabinet.
Press the harness from
the interceptor board into
the forks on the sensor
housing.
Remove the #8x16 screws
(2x) from the sensor
housing.
CHANGE THE DOOR HINGES (OPTIONAL)
Moving the sensor housing
1 54
2 6
3 7