User Manual
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
18
IMPORTANT!
Make sure the bracket overlaps the appliance
by a minimum 71/8” (180mm) for a secure
hold (E).
If the minimum 71/8” (180mm) overlap
cannot be achieved, install a solid spacer to
the wall stud behind the bracket (F).
!3ATTACH THE ANTI-TIP BRACKET
min 7 1/8”
(180mm)
E
Bracket
Appliance Wall
F
Bracket
Spacer
min 7 1/8”
(180mm)
Wall
Appliance
1 Project horizontally from the bottom end of the
alcove return towards the back wall (A).
– This will locate the contact surface between
the bracket and the appliance.
2 Mark the screw locations of the anti-tip bracket on
the wall based on the most central wall stud (B).
– If there are no wall studs, the bracket can be
installed to solid brick walls with masonry
plugs. (However, not recommended to be
used on perforated brick or hollow concrete
bricks).
3 Drill screw holes to the marked locations.
4 For wooden/plaster board wall installation:
Skip to step 5.
For solid wall installation: Hammer 10x30mm
masonry plugs (x4) into the wall until flush.
5 Fix the bracket to the wall with 10-12x35mm pan
head screws (4x), and screw tightly (C).
A
Projection must be from
the alcove return towards
the bottom of the bracket
Bracket
IMPORTANT!
Ensure the appliance/s is stable when the door/s is open. The anti-tip bracket and fittings supplied must be fitted to the
wall of the finished enclosure to withstand a 220lb (100kg) load. If installed correctly, this will prevent the possibility of
the appliance tipping forward, when the door/s is open.
WARNING!
Read the following reminders before fastening with masonry plugs and/or screws to avoid serious injury or possible death:
Ensure the screws avoid electrical, gas and water conduits.
Ensure that the surface where the bracket is fastened can withstand a 220lb (100kg) load.
Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.
Do not use metallic materials that may corrode, stain and/or damage the enclosure.
Required components/tools:
anti-tip bracket assembly (843934)
– 1x anti-tip bracket (843933)
– 4x 10x30mm masonry plugs (880910)
– 4x 10-12x35mm pan head screws (847398)
Phillips screwdriver
marker/pencil
SINGLE INSTALL DUAL INSTALL
C
B
Wall
board
Wall
stud