User Manual
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
25
!6DUAL INSTALLATION
Positioning and aligning the first appliance inside the cabinetry
1 Coil the water hose flat behind the appliance. (Refer to ‘Connect to water and power
supply’).
2 Roll the first appliance (preferably, Freezer) inside the cabinetry (A).
– Ensure that the water hose is not run over to prevent damage and possible water leak.
3 Continue rolling the appliance into the cabinetry until the anti-tip bracket overlaps
[minimum 7 1/8” (180mm)] the back top surface of the appliance. (Refer to ‘Attach the anti-
tip bracket’).
4 Check the clearance between the floor and the feet. Ensure the rollers of the appliance can
roll freely on the floor.
Note: The appliance can be rolled first into the left side or right side of
the cabinetry depending on your preference.
5 Align the top cap of the first appliance flush with the front of the spacer (B).
6 Mark the step (C) of each alignment gauge based on the thickness of the door panel to be
installed to the door.
7 Align the marked steps of the gauges flush with the edges of the cabinetry side walls.
– Place a ruler on the steps of the alignment gauges to check if they are in line (D)
relative to the thickness of the door panel.
8 Check if the gaps between appliance and cabinetry side wall are even.
A
Required components/tools:
ruler
IMPORTANT!
Make sure that all feet engage the floor and evenly support the product. Tighten the
adjustment screw with screwdriver (do not use powered driver).
D
C
B