User Manual
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
38
@3INSTALL CABINET TRIMS
Install the top trim
1 Slide the top trim into hinge pocket of the cabinet (A),
and then engage the dual lock at the non-hinge side (B).
B
A
Install the center trims (for dual install only)
Note: Four (4) dual-lock strips are pre-installed along the center trim.
2 Position the trim between the throats of both cabinets. (D)
3 Push and press the trim on the appliances/throat (E).
Note: Make sure the top end of the trim is pushed up
against the alcove ceiling before fixing the position
1 Peel off the liners from the dual-lock strips. (C)
4 Press the center trim to fix the position. (F)
C
D
E
F
Required components/tools:
1x center trim
Required components/tools:
1x top trim