User Manual

39
@4INSTALL FLOW DIVIDER AND DOOR TRIMS
Required components/tools:

1x door flow divider (843693)

1x flow divider cap (847957)

1x 8Gx16 countersunk screw (840597)

2x trim caps

top door panel extrusion

2x door panel side extrusion (843266)

saw

file
IMPORTANT!
The door flow divider is pre-assembled to the door of the appliance. It blocks the air flow
from bypassing in front of the bottom grille.
Install the flow divider
1 Peel the adhesive layer off the flow divider (A).
2 Remove the 8Gx16 countersunk screw from the bottom of the door and
re-install the flow divider using the same screw. (Do not tighten fully) (B).
3 Press the flow divider firmly against the door panel (C). Make sure the
adhesive layer contacts the door panel.
4 Re-tighten the screw fully.
Expose adhesive Exploded with machine screw
Twist to prise open
Cut airflow divider for 6” toekick
E
Install the door trims
1 Insert two (2) trim caps (E) into the top door
panel extrusion.
2 Align the notch on the top door panel extrusion
(F) with the magnet housing at the top of the
door (G) and clip door top trim assembly into the
magnet housing.
3 Press the top door panel extrusion down into the
top of the door (H) so that the dual lock strips
engage together.
Note: When fitting the air flow divider to the
door for a kickstrip height greater than 4”
(102mm), the divider requires shortening. This
is done by cutting along the cutline on both the
divider and divider cover (E) before installation
to the door. Ensure to file the cut portions of the
divider and cover.
5 Attach the flow divider cap to the flow divider (D).
B
C
D
A
4 Press the door panel side extrusion (I) into the gap between the door and door panel. Align
the top of the door panel side extrusion with the top door panel extrusion. Do on each side.
I
I
I
I
H
H
E
F
G
E