User Manual
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components list
- 4 Product dimensions and specifications
- 5 Cabinetry options
- 6 Cavity dimensions
- 7 Door and toe kick panel dimensions
- 8 Custom door panel dimensions
- 9 Door opening rotation
- 10 Electrical and plumbing
- 11 Before installation
- 12 Unpacking and moving your product
- 13 Attach the anti-tip bracket
- 14 Connect to water and power supply
- 15 Single installation
- 16 Dual installation
- 17 Install water filter
- 18 Install brackets to door panel (Stainless steel)
- 19 Install brackets to door panel (Custom)
- 20 Install door panels
- 21 Install toe kick
- 22 Install kickstrip grille
- 23 Install cabinet trims
- 24 Install flow divider and door trims
- 25 Optional — Changing over door hinges
- 26 Final checklist
41
@5OPTIONAL—CHANGING OVER DOOR HINGES
Removing the top door hinge
1 Rotate the top hinge (A) outwards and remove
the top hinge pocket cover (B) using the flat
head screwdriver in the slot of the cover.
2 Remove the hinge by unscrewing the M5x12
pan head screws (2x) (C), and set aside for
later use.
3 Remove the hinge pocket and top alcove
bracket by unscrewing M5x12 pan head screws
(2x) (D) from the hinge pocket.
4 Remove the top hinge bracket and spacer (E)
by unscrewing the M5x12 countersunk screws
(2x) from the top hinge bracket.
5 For the non-hinge side, remove the top alcove
bracket by unscrewing the M5x12 pan head
screws (2x) (F). (Not applicable for RS18).
Removing the bottom door hinge
6 Rotate the bottom hinge (G) outwards and
remove bottom hinge pocket cover (H) using a
flat head screwdriver in theslot.
7 Remove the hinge by unscrewing the M6x16
countersunk screws (2x) (I).
8 Open the water filter hatch on the bottom
(fixed) grille and unscrew the #8x16 screw (J)
while holding the grille in place.
9 Remove the bottom grille by unscrewing the
#8x16 screws (K) from the bottom left and
right of the grille.
!0
Remove bottom hinge bracket by unscrewing
M6x16 countersunk screws (L).
IMPORTANT!
Do not remove plinth-to-cabinet retention
brackets!
Required components/tools:
star T20 screwdriver
flat head screwdriver
A
G
E
C
D
F
J
L
B
K
I
K
H
Do not remove!
Do not remove!