User Manual

43
@5OPTIONAL—CHANGING OVER DOOR HINGES
Top hinge installation
1 Reinstall the hinge top bracket and bracket
spacer with M5x12 countersunk screws (A) on
the new hinge side at the other side of the
appliance.
2 Install the new hinge pocket and alcove top
bracket on the new hinge side using two (2x)
M5x12 pan head screws (B).
Note: The new hinge pocket and alcove top
bracket are supplied with the hinge kit.
3 Install the new hinge in the new hinge pocket by
screwing M5x12 pan head screws (2x) (C). (Not
applicable to RS18).
4 Open the hinge and reinstall the top hinge
pocket cover (D) to the top hinge pocket.
5 Install a new alcove top bracket on the new non-
hinge side. (Not applicable to RS18) (E).
Bottom hinge installation
6 Install a new lower hinge bracket on the new
hinge side with M6x16 screws (2x) (F).
– Ensure that the tab on the top of the
bracket inserts into the slot in the plinth
front bracket.
7 Use the hinge that was removed from the top of
the appliance and insert the tabs into the hinge
lower bracket. Rotate the hinge into place and fix
with M5x12 countersunk screws (2x) (G).
8 Open the hinge (H), and install the new top
(fixed) grille assembly.
9 Fasten in place with #8x16 screws (3x) (I). One
each at the bottom left and right of the grille and
one behind the water filter hatch.
!0
Reinstall the bottom hinge pocket cover to the
new hinge pocket (J).
Required components/tools:

left/right hinge change kit (refer to
‘Components list’ for part numbers)
– 1x top (fixed) grille assembly
– hinge change assembly

star T20 screwdriver

flat head screwdriver
H
A
C
B
E
I
E
I
J
F
I
G
D