Install Guide

25
Dimensions apply for the preparation and installation of Custom door panels. For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
z
The thickness of the custom door panel can vary provided that the screws do not penetrate beyond the full depth of the door panel.
z
Measurements of screw hole locations can vary depending on the height of toe kick 50–152mm.
CUSTOM DOOR PANEL INSTALL DIMENSIONS — RS30 MODEL
BOTTOM PANEL—REAR VIEW
Ensure handle is mounted
65mm from edge of panel
to the center—this will avoid
interference with bracket.
Ø2mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).
TOP PANEL—REAR VIEW
Ø2mm REF
10x Pilot holes recommended
for bracket attachment.
(Do not penetrate front surface).
14 7/8" (377.8mm)
8" (203.2mm)
29 3/4" (755.6mm)
1 1/4" (32.6mm)
2" (50mm) 15" (127mm)
20" (507.8mm)
43" (1092mm)
2" (50mm)
2" (50mm)
49 3/8" (1254mm)
2" (50.8mm)
14 7/8" (377.8mm)
8" (203.2mm)
2" (50.8mm)
29 3/4" (755.6mm)
1 1/4" (32.6mm)
2" (50mm)
1 1/2" (38.1m) 3 1/2" (88mm)
20" (508.4mm)
23 3/16" (588.4mm)
30 3/8" (771.5mm)
Cutouts in the hanging bracket
are applicable for Fisher &
Paykel handles only.
Iflocating a custom handle in
the shaded area shown above,
ensure handle screw headsare
countersunk into the back of the
door panel to avoid interference
with the hanging bracket.