Installation guide

18
IMPORTANT!
Make sure the bracket overlaps the appliance
by a minimum 71/8” (180mm) for a secure
hold (E).
If the minimum 71/8” (180mm) overlap
cannot be achieved, install a solid spacer to
the wall stud behind the bracket (F).
!3 ATTACH THE ANTI-TIP BRACKET
min 7 1/8”
(180mm)
E
Bracket
Appliance Wall
F
Bracket
Spacer
min 7 1/8”
(180mm)
Wall
Appliance
1 Project horizontally from the bottom end of the
alcove return towards the back wall (A).
– This will locate the contact surface between
the bracket and the appliance.
2 Mark the screw locations of the anti-tip bracket on
the wall based on the most central wall stud (B).
– If there are no wall studs, the bracket can be
installed to solid brick walls with masonry
plugs. (However, not recommended to be
used on perforated brick or hollow concrete
bricks).
3 Drill screw holes to the marked locations.
4 For wooden/plaster board wall installation:
Skip to step 5.
For solid wall installation: Hammer 10x30mm
masonry plugs (4x) into the wall until flush.
5 Fix the bracket to the wall with 10-12x35mm pan
head screws (4x), and screw tightly (C).
A
Projection must be from
the alcove return towards
the bottom of the bracket
Bracket
IMPORTANT!
Ensure the door of the appliance is closed when rolling into the cabinetry. DO NOT attempt to open the door until the
appliance is fully installed. The anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure
to withstand a 220lb (100kg) load. Ensure that the anti-tip bracket is installed correctly to prevent the possibility of the
appliance tipping forward when the door is open.
WARNING!
Read the following reminders before fastening with masonry plugs and/or screws to avoid serious injury or possible death:

Ensure the screws avoid electrical, gas and water conduits.

Ensure that the surface where the bracket is fastened can withstand a 220lb (100kg) load.

Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.

Do not use metallic materials that may corrode, stain and/or damage the enclosure.
Required components/tools:

Anti-tip bracket assembly
– 1x Anti-tip bracket
– 4x 10x30mm Masonry plugs
– 4x 10-12x35mm Pan head screws

Cross-head screwdriver

Marker/pencil
SINGLE INSTALL DUAL INSTALL
C
B
Wall
board
Wall
stud