Installation Guide

22
!5 SINGLE INSTALLATION
2 Continue turning the adjusting screws alternately between front and rear feet until
you achieve the correct alignment.
3 Once you are satisfied with the alignment, raise the height of the appliance by
alternately adjusting the front and rear feet until the top surface contacts the
alcove ceiling.

Check the alignment gauges while adjusting the screws to make sure you
maintain the alignment of the appliance.
4 Ensure all feet are positively engaged with the floor.
Rear footFront foot
A
Front foot
adjustment
Rear foot
adjustment
Adjusting height of the appliance inside the cabinetry
IMPORTANT!

Ensure the doors are in line with the cabinetry front and the appliance is centered.

All four corners of the appliance must be supported firmly onto the floor to
eliminate any movement. Installing the appliance on a soft, uneven, or not level
floor may cause twisting and poor door sealing.
Required components/tools:

Cross-head screwdriver or power driver (PH2 bit) at minimum torque setting
1 Fix each top bracket to the ceiling
surface with two 8Gx16 countersunk
screws (B).
– 18” (457mm) column = 1 bracket
– 24” (610mm) column = 2 brackets
– 30” (762mm) column = 2 brackets
Note: Make sure the appliance does not
move as you open the door when you
install the screws.
B B
C C
B
C
IMPORTANT!

Make sure to remove the depth alignment brackets before fixing the appliance inside
the cabinetry.

Open the appliance door to remove the alignment brackets from both sides of the
appliance, and then re-tighten the screws.
Required components/tools:

Cross-head screwdriver or power driver

6x 8Gx16 countersunk screws
2 Fix the alcove side brackets (1x per
each side) to the alcove side surface
with 8Gx16 countersunk screws (C).
Fixing the appliance inside the cabinetry
1 Turn the front and rear adjustment
screws using a Cross-head screwdriver
(or powered driver) to extend the feet
until it engages the floor.
– One turn of height adjusting nuts
is equivalent to 1/32” (0.5mm) of
height adjustment. Clockwise turn
raises the height and counter-
clockwise turn lowers height (A).