Installation Guide

31
!8 INSTALL BRACKETS TO DOOR PANEL (STAINLESS STEEL)
IMPORTANT!

Ensure to protect the finish of the Fisher & Paykel Stainless Steel door panels. Leave
the protective film on the panels when hanging and remove the film only when the
installation is complete.
Required components/tools:

Door panel attachment kit
– 6x Side panel brackets
– 6x Bracket slider
– 6x Side spacer bracket
– 30x 8Gx16 Mush washer screws (for
SS door panels only)

Drill with 3/32” (2.55mm) bit

Cross-head driver on battery drill

M4 hex key

1/2” (13mm) Spanner
4 Align the screw holes of the bracket with the screw holes of the door panel, and fix the
hanging bracket to the door panel with 8Gx16 mush washer screws (D).
– 6x screws for 18” (457mm)
– 10x screws for 24” (610mm) and 30” (762mm)
D
E
E
5 Align the side panel bracket assembly (bracket, slider and spacer) to the screw holes on the
side of the door panel and fix with 8Gx16 mush washer screws (E).
Attach the top and side hanging brackets to (Stainless steel) door panel
B
2 Remove the top hanging bracket from the
top of the door and set aside (B).
3 Unscrew the adjustment screws by 1/8”
(3mm) to move close to the middle of
adjustment range (C).
A
1/8”
(3mm)
C
1 Remove the M8 washer and M8 nut fromthe M8 screws at the top the door (A).