Quick Start Guide

35
@1INSTALL TOE KICK
4 Place the toe kick in front of the mounting plate. Ensure that the spacers at back of the toe
kick are aligned with the magnets (E).
– For custom toe kick, skip step 3 as spacers are not needed.
5 Attach the toe kick by pressing onto the mounting plate (F).
– For stainless steel: Ensure the adhesive tape of the magnets adhere to the spacers of
the toe kick.
– Ensure the bottom of the toe kick contacts the floor as you attach to the mounting plate.
IMPORTANT!
Two magnets are pre-installed to the bottom corners of the toe kick mounting plate. Each
magnet has double-sided tape to be attached to the toe kick. This allows both Stainless
steel and Custom panels to be attached to the magnet.
Required components/tools:

1x air kickstrip seal (846405)

1x toe kick
Installing the toe kick mounting plate and toe kick
1 If the toe kick depth is less than 35/8” (92mm), attach the air kickstrip seal (A) to the
middle of the back side of the mounting plate (B).
2 Attach the toe kick mounting plate (C) to the plinth.
F
3 Peel off the adhesive tape backing of the magnets located at the front bottom
corners of the toe kick mounting plate (D).
D
E
B
A
C
IMPORTANT!

For toe kick heights 41/2” – 5” (114–127mm), shorten the lower grille by cutting along
the vertical ribs.

For 2” (51mm) toe kick height, an additional lower grille can be ordered.

For toe kick heights greater than 5” (127mm), lower grille is not required.

Refer to ‘Door and toe kick panel dimensions’ for more information.