Installation Guide
Table Of Contents
- Safety and warnings
- Integrated refrigerator & freezer
- Integrated refrigerator-freezer
- Integrated wine cabinet
- Supplied parts
- Required parts
- Door panel kit
- Handle kit
- Hinge change kit
- Wine display accessories
- Tools
- Product dimensions
- Cabinetry dimensions — Single installation
- Cabinetry dimensions — Multiple installation
- Stainless steel Door panel dimensions — Single installation
- Custom Door panel dimensions — Single installation
- Custom Door panel dimensions — Multiple installation
- Toe kick dimensions
- Installation options
- Door clearance
- Drawer clearance
- Electrical and plumbing
- Custom door panel install dimensions
- Before installation
- Cavity preparation
- Appliance preparation
- Door panel preparation — Stainless steel panel
- Door panel preparation — Custom panel
- Door panel preparation — Wine cabinet only
- Power and water supply connection
- Install water filter
- Single installation — Align appliance into cabinetry
- Single installation — Secure appliance into cabinetry
- door panel installation
- Toe kick installation
- Grilles installation
- Carbon filter installation
- Air flow divider installation
- Cabinet trims installation
- Top trim & hinge pocket covers installation
- Multiple installation — Appliance preparation
- Multiple installation — Align first appliance into cabinetry
- Multiple installation — Secure first appliance into cabinetry
- Multiple installation — Align second appliance into cabinetry
- Multiple installation — Secure second appliance into cabinetry
- Multiple installation — Install cabinet trims
- Wine display for Wine cabinet (optional)
- Change the door hinges (optional)
- Final checklist
30
CAVITY PREPARATION
Anti-tip bracket
assembly kit
Anti-tip bracket (1x)
Masonry plug (4x)
#10x40
Pan Head
Philips Screw
#10x40
Pan Head
Philips Screw
#10x40
cross-head screw (4x)
Tools
Cross-head
screwdriver
Powered drill
Pencil
min 7 3/4"
(197mm)
bracket
Floor
A
B
overhead
cabinetry
back wall
PROFILE VIEW
For solid wall installation
Drill holes suitable to the size of the
masonry plugs.
Hammer 10x30mm masonry plugs into
wall until flush. Fix bracket to wall with
#10x40mm cross head screws, and screw
tightly.
For plaster board wall
Fix the anti-tip bracket to the wall with
#10x40mm cross head screws, and screw
tightly into the stud with a screwdriver.
1
2
3
4
5
Attaching the anti-tip bracket
Measure the height (A) of the attachment
location from the floor to the alcove
return.
z
The height (A) must not exceed
84 3/16" (2138mm) to ensure the
appliance does not tip over during
installation.
Mark a horizontal line (B) at the back wall.
z
Ensure there is a stud behind the wall.
Place the bracket to the backwall. Align
the undersurface of the bracket along the
marked line.
Mark screw hole locations, and drill screw
holes with powered drill.
When rollng the appliance into the
cabinetry, ensure the anti-tip bracket
overlaps the back edge of the appliance.
z
The bracket must overlap the appliance
by a minimum 7 1/16" (180mm) for a
secure hold.
If minimum 7 1/16" (180mm) overlap
cannot be achieved, install a solid spacer
to the wall stud behind the bracket.
z
Be careful not to run over the power
cord when rolling in the appliance.
Illustrations may differ from your purchased appliance.