Installation Guide
Table Of Contents
- Safety and warnings
- Integrated refrigerator & freezer
- Integrated refrigerator-freezer
- Integrated wine cabinet
- Supplied parts
- Required parts
- Door panel kit
- Handle kit
- Hinge change kit
- Wine display accessories
- Tools
- Product dimensions
- Cabinetry dimensions — Single installation
- Cabinetry dimensions — Multiple installation
- Stainless steel Door panel dimensions — Single installation
- Custom Door panel dimensions — Single installation
- Custom Door panel dimensions — Multiple installation
- Toe kick dimensions
- Installation options
- Door clearance
- Drawer clearance
- Electrical and plumbing
- Custom door panel install dimensions
- Before installation
- Cavity preparation
- Appliance preparation
- Door panel preparation — Stainless steel panel
- Door panel preparation — Custom panel
- Door panel preparation — Wine cabinet only
- Power and water supply connection
- Install water filter
- Single installation — Align appliance into cabinetry
- Single installation — Secure appliance into cabinetry
- door panel installation
- Toe kick installation
- Grilles installation
- Carbon filter installation
- Air flow divider installation
- Cabinet trims installation
- Top trim & hinge pocket covers installation
- Multiple installation — Appliance preparation
- Multiple installation — Align first appliance into cabinetry
- Multiple installation — Secure first appliance into cabinetry
- Multiple installation — Align second appliance into cabinetry
- Multiple installation — Secure second appliance into cabinetry
- Multiple installation — Install cabinet trims
- Wine display for Wine cabinet (optional)
- Change the door hinges (optional)
- Final checklist
43
DOOR PANEL INSTALLATION
Tools
Cross-head
screwdriver
M4 hex key (1)
13mm spanner (1x)
Adjust the depth of door panel
Re-adjusing the door panel
Adjusting the height of door the panel
Ensure the side brackets are loosely screwed when adjusting the height of the
door panel. Do not adjust the door panel height when the side brackets are
screwed tight. This can generate friction which causes the hanging brackets to
bend.
To adjust door panel further, remove the
door panel then loosen the fixing screws
of the hanging bracket and move the
bracket sideways to suit.
To adjust door panel further, remove the
door panel then loosen the fixing screws
of the hanging bracket and move the
bracket sideways to suit.
z
Once satisfied with door panel position,
fully tighten M8 washer and nut to
adjustment screw.
Loosen side screws on the side
brackets, and slide door panel
forward/backward.
Re-tighten once satisfied.
Lower
Raise
Turn the adjustment screw to raise
or lower the height of the door panel
relative to the door.
Continue adjustment until gap with
cabinetry is more than 3mm.
z
Do not adjust the adjustment screw
higher than 1/4" (6.5mm) from its
fully down position.
Illustrations may differ from your purchased appliance.