Installation Guide

25
Align appliance inside the cabinetry
1 Centre the appliance within the alcove, using the adjacent
walls as a guide.
2 Raise the front of the appliance until the fixing brackets
contact the ceiling of the enclosure (A).
z
Turn the front and rear adjusting nuts (B) clockwise to
raise the roller or counter-clockwise to lower the roller.
3 To achieve correct alignment between front of the doors
and adjacent cabinetry panels, turn the adjusting nuts
alternately between front and rear rollers.
4 Check the gaps top and bottom, left and right by placing a
ruler on the front of the appliance.
z
Ensure the gaps between appliance and adjacent
cabinetry are even on both sides (C).
z
This step will help ensure the appliance is level with the
adjacent cabinetry
5 Gently push the front of the appliance to check
the stability
Supplied tools
Hex key
Tools
Ruler
Powered driver (optional)
Cross-head screwdriver
IMPORTANT!
●
Ensure all four corners of the appliance is supported firmly onto the floor
to eliminate any movement.
●
DO NOT install the appliance on a soft, uneven, or unlevelled floor
toavoidtwisting the appliance and poor door sealing.
●
We recommend to use A 4mm hex key.
●
One turn of height adjusting nuts is equivalent to 1mm heightadjustment.
Note: Maximum height adjustment is 13/16" (20mm).
●
If using a powered driver, use low torque setting to avoid the nut
disengaging from the rod and damaging theleveling system. If the nut
disengages, use the hex key to realign with rod.
●
Ensure that the top, bottom and side gap differences are not greater than
1.5mm to achieve correct alignment.
●
Finalalignment will be achieved once door panels have been installed
andthe appliance is pushed back to sit flush with the cabinetry.
!8 ALIGNING INSIDE CABINETRY
Place a ruler on the
front of the appliance to
check flushness top and
bottom, left and right
BB
C
Rear roller adjustment
Front roller adjustment
A