Install Guide - Water Filter Replacement

1
1 SAFETY AND WARNINGS
847200 – Certified by: IAPMO R&T against NSF/ANSI Standards 43, 53, 401 and
CSAB4831.1 for the reduction of claims specified on the performance data sheet
and at iapmort.org. 847200 compounds certified under NSF/ANSI 401 have been
deemed as incidental contaminants/emerging compounds. Incidental contaminants are
those compounds that have been detected in drinking water supplies at trace levels.
Whileoccurring at only trace levels, these compounds can affect the public acceptance
of drinking quality water.
847201 – Certified by: IAPMO R&T against NSF/ANSI Standards 43 and CSA B4831.1
forthe reduction of claims specified on the performance data sheet and at iapmort.org.
Rated capacity
847200 – 102 gallons (386 litres)
847201 – 170 gallons (643 litres)
Flow rate
0.5 gpm (1.89 Lpm)
Replacement filter cartridges can be purchased online at fisherpaykel.com or
bycallingFisher&Paykel Customer Care. Details of the replacement filter cartridge
arelabelledon the cartridge.
Office address
Fisher & Paykel Appliances Ltd
PO Box 58550
Botany
Auckland 2163
New Zealand
Customer Care
Phone: [phone]
Water filter
IMPORTANT!

The water connection to your ice & water refrigerator must be installed by an qualified
plumber or Fisher & Paykel trained and supported service technician and comply with
all state and local laws.

Installation and use MUST comply with all state and local plumbing codes. Checkwith
your local public works department for plumbing codes. You must follow their
guidelines as you install the water filtration system.

To avoid serious illness or death, only connect your water filter to safe drinking water.

The water filter cartridge needs to be changed when the replacement indicator icon
illuminates. This will happen every 6 months.

If the water filtration system has been allowed to freeze, replace filter cartridge.
Failure to replace the disposable filter at recommended intervals may lead to reduced
filter performance and failure of the filter, causing property damage from water
leakage or flooding.

In cases of excessively reduced filter life — we recommend that you consult a local
plumber or your water supplier for advice on suitable filtration requirements for the
water supplied to your home.

Filter replacement is the consumer’s responsibility and will not be covered by the
warranty except in the case of faulty parts or materials within the filter cartridge.

If the water has not created ice for some time or ice has an unpleasant taste or odor
dispose of ice and refer to the flushing instructions in this book. If unpleasant taste or
odor persists, you may wish to fit a new filter cartridge.

Your water filtration system can withstand up to 120psi (827kPa) of water pressure.
Ensure the supplied pressure reducing valve is installed before installing the water
filtration system. DO NOT install if water pressure exceeds 120psi (827kPa).
To reduce the risk associated with property damage due to water leakage or flooding:

DO NOT install systems in areas where ambient temperatures may go above 100°F
(38°C) or drop below 33°F (0.6°C).

DO NOT install on hot water supply lines. The maximum operating water temperature
of this filter system is 100°F (38°C).

DO NOT install where water hammer conditions may occur. If water hammer
conditions exist, you must install a water hammer arrester.