Installation Guide
Table Of Contents
- Introduction
- Safety and warnings
- Installation instructions
- Moving or storing your appliance
- Operating instructions – Internal control panel
- Operating instructions – Special functions
- Interior and exterior features
- Storing your wine
- Loading your wine bottles
- Cleaning care – Exterior
- Cleaning care – Interior
- User warnings and sounds
- Troubleshooting
- Manufacturer’s Warranty
- Customer Care
- European Directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE)
- Product fiche
8
INSTALLATION INSTRUCTIONS
Please follow the installation steps below to ensure your appliance operates correctly.
Power
The appliance must be installed so the plug is accessible.
To ensure that the appliance is not accidentally switched off, connect your Wine Cabinet
to its own power point. Do not plug in any other appliance at this power point.
For power requirements, please refer to the serial plate located on the rear of the
cabinet.
It is essential that the appliance is properly grounded (earthed).
Connect the appliance to the electrical supply (220V–240V50Hz) with the fitted
plug and lead.
Connections to the mains supply should be in accordance with local regulations.
Location
Your Wine Cabinet should not be located in direct sunlight or next to any heat
generating appliance such as a cooktop, oven or dishwasher.
The appliance should not be located in garages or on carpeted floors.
This appliance is intended to be used in indoor ambient temperatures between 16°C
and 25°C. Do not operate this appliance outside the specified ambient ranges as
performance may be compromised.
Ventilation and installation
To ensure adequate ventilation for your Wine Cabinet, see ‘Product and cabinetry
dimensions’.