Installation Guide
Table Of Contents
- 1 Safety and warnings
- 2 Integrated columns
- 3 Components
- 4 tools
- 5 dual install options
- 6 appliance dimensions and specifications
- 7 Cabinetry options
- 8 Cavity dimensions
- 9 Door and toe kick panel dimensions
- !0 Custom door panel dimensions
- !1 Door clearance
- !2 Electrical and plumbing dimensions
- !3-A Electrical and plumbing specifications (FOR NZ & AU only)
- !3-b Electrical and plumbing specifications (for GB & EU only)
- !4 Before installation
- !5 cavity preparation
- !6-A water and power supply connection (For NZ & AU only)
- !6-b water and power supply connection (For GB & EU only)
- !7 Single installation
- !8 Dual installation
- !9 water filter InstallATION
- @0 door panel installation (Stainless steel)
- @1 door panel installation (Custom)
- @2 toe kick installation
- @3 cabinet trims Installation
- @4 door trims installation
- @5 Optional — Changing over door hinges
- @6 Final checklist
16
!2 ELECTRICAL AND PLUMBING DIMENSIONS
Cavity size shown for dual columns installation.
IMPORTANT!
●●
Electrical and water connections for these appliances must be located in an adjacent area
or unit (cabinet or cupboard) that is easily accessible in case of repair or disconnection.
●●
Once installed, the service technician will NOT remove the appliance from the cavity to
gain access for repair.
WARNING!
●●
Electric shock hazard! Assume all parts live.
●●
Disconnect supply before servicing and installation.
Floor
A
D
Electrical and water connections must be within this space if located
behind the appliance and must not protrude from the back wall.
Left side of cavity
REAR OF CAVITY
C
B
1
2
1
ELECTRICAL AND PLUMBING CONNECTIONS
1
Recommended location for connections in adjacent area or unit
2
Alternative location for connections at rear of cavity
ELECTRICAL AND PLUMBING DIMENSIONS mm
A
Overall height of supply area 229
B
Overall depth of supply area 25
C
Width of notch in supply area (both sides) 13
D
Height of sides of supply area (both sides) 127
Note: Dimensions are based on minimum depth of cavity.
IMPORTANT!
●●
Minimum overall depth of cavity should not be less than 650mm if power plug is
located behind the appliance.
●●
If connections are located behind the appliance, ensure that you install an isolating
switch to a location that is easily accessible for repair or disconnection.