Installation Guide

20
!4 BEFORE INSTALLATION
Side trim
assembly
Door panel
side extrusion
Centre trim
assembly
Top trim
Top door
panel
extrusion
Top grille
Bottom grille
Air flow
divider
Unpacking your appliance
1 Remove the top of the
packaging carton. Cut along
the cut lines and remove the
carton and EPS (Expanded
Polystyrene) foam.
2 Remove pre-packed install
parts taped to the back panel
of theappliance.
– Door panel side extrusion
– Side trim assembly
– Centre trim assembly
– Dual install joiner kit
Note: In some models, the install
parts are packed in a box taped
toback panel.
3 Remove/unscrew the
pre-installed parts.
– Top trim
– Top door panel extrusion
– Toe kick mounting plate
– Top grille
– Bottom grille
– Air flow divider
Note: Set aside the screws touse later
when reinstalling the removedparts.
Do not remove the central
magnet
housing (circled) from
the top of the appliance.
IMPORTANT!
●●
Be careful when unpacking to prevent damage to the surface of your appliance.
●●
Ensure that the appliance is stable to prevent from tipping over when unpacking.
●●
Do not open the doors to prevent the appliance from tipping over.
●●
The appliance is heavy and requires a minimum of 2 persons to unpack and install.
●●
Ensure that the feet of the appliance are retracted.
●●
If the appliance is damaged, contact your Fisher & Paykel dealer.
●●
Take note of your model and registration numbers located at the lower right side of the
appliance. You will need these to request for servicing or repair of your appliance.
WARNING!
●●
Follow these steps to avoid risks that can
cause serious injury or death.
●●
Keep doors closed until the appliance has
been moved to its installation location.
magnet housing
Toe kick
mounting plate
4 Restrain the
appliance tothe
cartwithstraps.
5 Remove the
brackets on the
other side of
theappliance.
Moving your appliance
1 Remove the brackets from one side of
the appliance. (Preferably, non-hinged
side of the appliance.)
6 Tilt the appliance backward
onto the cart.
7 Set aside the pallet and
push the cart to the
installation location.
2 Tilt the appliance
slightly to the
opposite side.
3 Insert the hand truck
under from the side of
the appliance where the
brackets were removed.
Do NOT insert the hand
truck to the front or
back of the appliance.
hand truck