Installation Guide

22
IMPORTANT!
●●
Old water fittings (hose-sets) should not be reused.
●●
The appliance includes a stainless braided water line hose.
●●
The shut off valve should be accessible.
●●
Make sure each appliance is connected to a separate power socket.
WARNING!
●●
The water connection steps below are intended only for the
professional installer.
●●
WARNING — connect to potable drinkable water supply only.
●●
DO NOT install on line pressure above 120psi (827kPa) or below 22psi (150kPa).
●●
DO NOT use on hot water supply (100°F [38°C max.]).
Water fittings kit
(Ice and Water
modelsonly)
Collet locking clip
(1)
1/2 BSP Stainless steel
braided hose with
adaptor (1)
!6-A WATER AND POWER SUPPLY CONNECTION (FOR NZ & AU ONLY)
D
C
4 Pull the adaptor end of the braided hose all the way to the
front of the appliance and insert the tube end of the adaptor
fully into the PRV (C).
5 Secure the connection with a locking clip between the PRV
andhose end of the adaptor (D).
6 Check the connection and open the water supply to testfor leaks.
Note:
– The water supply connection is applicable for freezer
models only.
– For dual installation, do the steps forboth first and
second appliances.
Connecting to power supply
7 At the back of your appliance, uncoil the power cord from the
clips (E) and connect to the power supply (230 VAC, 50 Hz) (F).
– You will hear a chime sound when the appliance is
powered on and automatically goes into ‘Installer
(standby) mode’.
– Refer to ‘User guide’ for more details on activating
the appliance.
Connecting to water supply (for Ice and Water models only)
1 Move the appliance in front of the cabinetry close enough that you can access
behind for power and waterconnections.
2 Connect one end of the braided water hose to the water tap (A). Flush water
through the hose prior to connection to the appliance to remove any debris in
the hose.
3 Insert the adaptor end of the hose through a hole at the rear of the plinth (B).
B
Rear view
ofappliance
E
A
F